о
О-
со
+104
+94
+84
+74
+64
10 20 50 100 200 500 1000 2000 5000 10000 20000
FREQUENCY IN HZ
Figure 1. 418-8H Frequency Response Measured at 4' on Axis with 1 Watt Input
ARCHITECT'S AND ENGINEER'S SPECIFICATIONS
The musical instrument loudspeaker shall have a maximum diameter of 15-5/16"
and shall weigh 14 pounds, 6 ounces. It shall have a structurally reinforced die-cast
aluminum frame which shall be rigid enough to permit front or rear mounting. The
voice coil shall be 3" in diameter, of edge-wound copper ribbon, and shall operate
in a magnetic gap having a flux density of 13,000 gauss. The loudspeaker shall have
an Alnico V permanent magnet weighing not less than 2.4 pounds. The magnetic
structure shall have a metal dust cover to protect it from dirt, iron particles and
magnetic dust. The cone-surround area shall be of high-compliance cloth. The
musical instrument loudspeaker shall meet the following performance criteria. Power
rating, up to 150 watts of continuous program material. Frequency response, uni
form from 45 to 8000 Hz. Pressure sensitivity; 99 dB SPL with 1 watt input of
band-limited pink noise from 100 Hz to 10 kHz measured on axis 4' from cone, 98
dB SPL with 1 watt input of band-limited pink noise from 100 to 1000 Hz measured
on axis 4' from cone (Ref.: 0.0002 dyne/cm^). Equivalent El A rating, 52 dB SPL
measured on axis 30' from cone with 1 milliwatt input. Nominal impedance, 8
ohms. Nominal free-air cone resonance, 55 Hz.
The musical instrument loudspeaker shall be the ALTEC Model 418-8H.
Kommentare zu diesen Handbüchern